stayer PBL222PK Manual De Instrucciones página 23

= Battery charging time
= No load speed
rpm
= Tightening torque
= Percussions
ipm
= Wood drilling capacity
= Steel drilling capacity
= Stone drilling capacity
= Weight
= Sound power level
= Sound pressure level
= Vibration
The values given are valid for nominal voltages
[U]230/240 V-50/60 Hz - 110/120 V - 60Hz. For lower
voltage and models for specific countries, these values
can vary.
Declaration of Conformity
The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 91 691 86 30 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
Cordless drill/screwdriver
Type:
We declare under our sole responsibility that this
product is in conformity with the following standards or
standardized documents: EN 60745-1, EN 60745-2-2,
EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-
3, according to EU Regulations 2006/42/EC,
2014/30/EU.
Ramiro de la Fuente
Director General
Assembly
Battery Charging
f Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
ENGLISH
January 5, 2017
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
Do not continue to press the
On/Off switch after the ma-
chine has been automatically switched off. The
battery can be damaged.
To remove the battery 5, press the battery un-
locking button 9 and pull the battery out of the
power tool toward the rear. Do not exert any
force.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0º C and 45º C. A
long battery service life is achieved in this manner.
Observe the notes for disposal.
Changing the Tool
f Before any work on the machine (e. g .,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Open the keyless chuck 2 by turning in rotation
direction , until the tool can be inserted. Insert
1
the tool.
Firmly tighten the collar of the keyless chuck 2
by hand in rotation direction
cally locks the drill chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direction.
Dust/Chip Extraction
f Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
23
(not aply to 202-204 models)
. This automati-
2