Velleman CAMCOLD12N1 Manual Del Usuario página 3

4. Installation
 Turn the plastic dome cover counter clockwise and remove it.
 Use the base to determine the location of the mounting holes and hole for
the video/power cable.
 Screw the base in place using 4 screws and connect the
video/power cable. There is only one way to fit the
connector, do not force.
 Connect the video [1] and power cable [2].
 Aim the camera and close the dome. Align the
protrusions and notches, insert and rotate the plastic
cover ±60° clockwise. Make sure the camera has a clear
view.
5. Technical specifications
IP rating
pick-up element
pixels
horizontal resolution
min. illumination
S/N ratio
electronic shutter
lens
lens angle
iris mode
gain control
white balance
video output
power supply
dimensions
weight
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulted from
(incorrect) use of this device. For more info concerning this product,
please visit our website www.velleman.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned
by Velleman nv. All worldwide rights reserved. No part of this manual may
be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
V. 01 – 17/09/2014
CAMCOLD12N1
n/a
1/3" CCD
976(H) x 582(V) – PAL –
700 TV lines
0.1 lux
> 48 dB (AGC off)
1/60 (1/50) to 1/100 000 s
f3.6 mm / F2.0
79°
AES
Auto
ATW
1 Vpp @ 75 ohms
12 VDC (use PSSE1205, not incl.)
Ø 100 x 60 mm
100 g
3 ©Velleman nv