Glacier bay BD601100NP Guía De Uso Y Cuidado

TOOLS REQUIRED
Phillips Electric drill
screwdriver
Installation
1
Determining the mounting
location
Determine the location where you wish to
install your accessory.
Place the mounting bracket (BB) at the
desired location and mark the installation
holes using a pencil.
Pencil
2
Installing the bracket in
drywall
Drill a 1/8 in. pilot hole at each pencil
mark made.
Align the mounting brackets (BB) with
the E-Z Ancor
mounting screws (CC).
Drive the E-Z Ancor
using a Phillips screwdriver until flush
with the wall.
BB
USE AND CARE GUIDE
HARDWARE INCLUDED
AA-E-Z Ancor
x4
DD-Hex wrench
x1
Claw
hammer
(AA) and secure with the
®
(AA) into the wall
®
NOTE: To install the bracket in a wood stud,
proceed to Step 3. To install the bracket in
ceramic tile, proceed to Step 4.
AA
BB
CC
1
Item #532-101
Model #BD601100NP
TOWEL BAR
BB-Mounting bracket
®
x2
EE-Set screw
x2
3
Installing the bracket in a
wood stud
Drill a 3/32 in. pilot hole at each pencil
mark made.
Align the mounting brackets (BB)
with pilot holes and secure with the
mounting screws (CC).
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
532-114
BD601200NP
CC-Mounting screw
x4
FF-Masonry wall anchor
x4
BB
CC