Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
3. Insert the Bottle Jack pin to connect the Bottle Jack to
the Lift Bracket. The bottle jack needs to be pumped
to the point that the bottle jack can connect to the
bracket. Secure with clip.
NOTE: If holes do not line up, twist the Bottle Jack
Ram until they are aligned.
Figure 4: Inserting Bottle Jack Pin.
4. Install Wheel Baskets into the Front Tube with the nut
and bolt provided. Repeat for other side.
Figure 5: Wheel Basket attachment.
5. Install Handle Yoke onto Lift Bracket using (2) M6
bolts and nuts. When installing the Handle Yoke, the
slit needs to be face up.
Figure 6: Handle Yoke assembly.
6. Install Foot Pedal into Foot Pedal Sleeve and secure
with M5 phillips screw.
Figure 7: Foot Pedal assembly.
7. Insert Handle and twist to secure pin in Yoke slot.
Figure 8: Handle assembly.
8. After assembly, ensure lift rolls freely, lifts, locks and
lowers easily, and the Bottle Jack operates smoothly
before putting into service. Familiarize yourself with
operation of Height Locking Lever and Foot Pedal.
Make sure all nuts and bolts are secure and locked
tight
NOTE: The wheel baskets provided are meant for
larger wheels. A cross bar has also been provided
to be installed inside the basket to accommodate
smaller diameter tires. Ensure that your lifting
basket is set such that the lawn mower tire cannot
fall through the basket.
OPERATION
1. The cross bars, located in the baskets, have been
included for smaller tires. If your tires fit securely
into the baskets with the cross bars in, leave the
cross bars in place. If they do not fit securely into the
baskets, remove the cross bars, so the tires will fit
more securely.
2. Drive Mower onto the wheel baskets and position
mower tire securely on wheel baskets centering the
load on the lift.
3. Leave Mower Transmission in neutral. Use the
notched end of the handle to engage and turn the
release valve clockwise until firm resistance is felt
to further turning. (This is the "Closed" release valve
position used to raise the ram plunger.) Carefully
pump jack until mower reaches desired height. Final
height must correspond with the locking teeth on the
Height Locking levers.
4. Carefully turn the Release valve counter clockwise,
slowly, until the Lift Platform locking levers engages
the Height Locking Levers then close the release
valve by turning it fully clockwise until firm resistance
is felt.
5. Secure the mower by setting the parking break,
putting the transmission in gear and chocking the
wheels.
4
Publicidad
