Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Make sure that before you connect the speaker, the ON/OFF switch
is in the off position and the volume controls are at the minimum
This kit is ideal for electronic students or hobbyists because
level. If this is not the case, your speaker may suffer overcharge
damage.
1. Connect the power cable to the electric outlet and connect the other
end of the power cable to the speaker.
2. Connect a microphone to the input jack labeled MIC IN through the
6.3 mm plug or cannon plug.
3. Use the RCA Line In input jacks in order to connect a CD, MP3, DVD,
or other type of audio device.
4. Power all the devices on. A green LED indicator light will illuminate
indicating that the speaker is powered on.
5. Adjust the volume levels of the connected devices (CD, MP3, etc.) as
well as the line in level on the speaker. Also adjust the Bass and treble
levels in order to equalize the sound.
6. The red LED indicator light will illuminate if an overcharge is detected.
This occurs in order to protect your speaker. The volume levels should
be reduced in order to prevent serious damage to the speaker.
Do not place the microphone near the speaker. Doing so could
cause an echo as well as damage to the speaker.
ENGLISH-06
Publicidad
