Publicidad
Idiomas disponibles
Idiomas disponibles
OPErATION
WArNING:
important safety warning and instructions before using this tool.
WArNING:
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY
PACK (FIG 2)
• To install the battery pack, slide the battery pack (7) into the
bottom of the tool housing all the way until it locks in place with
a click, as shown in fIG 2. Lightly pull on the battery to ensure it
is locked into place and will not accidentally fall out of the tool,
causing an injury.
• To remove the battery pack, pull the battery pack away from the
tool while depressing the battery locking tab (6).
CHARGING THE BATTERY (FIG 3)
NOTE:
Always check that the power supply corresponds to the
voltage on the ratings plate.
• Plug the charging adaptor (10) into a 120 Volt AC power
source. The green light on the charging adaptor will illuminate,
indicating it is powered.
• Connect the charging adaptor to the battery (7) as shown in
fIG 3. The red light on the charging adaptor will illuminate,
indicating that the battery is charging.
• The red light will turn to green light after charging is complete.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool
down to room temperature before charging. This will extend the
life of your batteries.
NOTE:
It takes approximately 3-5 hours to charge up a
completely discharged battery.
WArNING:
in the locked or off position before any assembly, adjustments or changing accessories.
TRIGGER SWITCH ACTION
• Turn the drill on by depressing the trigger switch (3-fIG 1).
• Depressing the switch further will produce more speed and torque.
• use the reversing switch (4-fIG 1) to change the direction of rotation of the drill.
• The reversing switch has three positions: forward, Reverse, and off (middle).
• Always check the rotation before beginning your work.
LED WORK LIGHT
Your tool has a built-in LED work light (5-fIG 1) to illuminate the work area. When you turn on the tool, the work
light will automatically turn on.
BATTERY POWER INDICATOR
There is a battery power indictor (9-fIG 1) on the battery pack. It has three green lights. Depress the power
indicator button on the side to check the battery power level. When all three lights illuminate, it indicates the
battery is at full power. The battery is at half full power when two lights illuminate. When one light illuminates
only, it indicates that the battery is at low power level and requires immediate charging.
ELECTRIC BRAKE
This drill is equipped with an electric brake. Like the torque settings, an electric brake provides you with another
element of control during various operations. If the tool consistently fails to quickly stop after the trigger switch is
released, have a qualified serviceman examine the tool.
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
Always disconnect the battery pack from the tool or place the switch
6
7
10
7
FIG 2
FIG 3
9
Publicidad
