EN
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
11.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Do not oil the blade while the hedge trimmer is running.
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
12
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
13
TROUBLESHOOTING
Problem
The motor shuts
down whilst work-
ing.
The machine
smokes during op-
eration.
NOTE
NOTE
Possible cause
Solution
Make sure that
The battery pack is
you tighlty instal-
not installed tight-
led the battery
ly.
pack in the ma-
chine.
The battery pack is
Charge the battery
out of power.
pack.
The machine has
Do not use the ma-
damage.
chine and speak to
service center.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
English
Problem
The motor is on,
blades do not
move.
Too much noise
and/or vibration is
experienced while
working.
14
TECHNICAL DATA
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
Charger model
15
LIMITED WARRANTY
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion, will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been purchased or rented for industrial/commercial use, and
10
Possible cause
Solution
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are
then clear block-
blocked.
age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are loos-
3. Inspect for
en.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
24 V
3000 (±10%) SPM
20" (510 mm)
0.7" (18 mm)
8.8 lbs. (4 kg)
BAG 708 and other BAG
series
CAG 801 and other CAG
series
3
YEAR
ANS
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA