Publicidad
Idiomas disponibles
Idiomas disponibles
fit FOOT RAILS
A
(
)
Starting at the front windscreen as shown, measure along the Ditch Moulding towards the rear of the
vehicle. Mark the Ditch Moulding at the following distances 240 mm, 375 mm, 1245 mm and 1410 mm.
Start to Measure at
Front of Windscreen
B
(
)
Using a pair of tin snips, cut the Ditch Moulding on
each of your marks and remove the small strips of
Ditch Moulding between markings 1-2 and 3-4.
Looking at the ditch, where you have just removed the
Ditch Moulding, locate the two Threaded Mounting
Points in the vehicle's roof and remove the Protective
Tape covering them.
( C )
Put a small amount of silicone over each Mounting Point and place
a Spacer (Item 8) on top of the Silicone, lining up the hole in the
Spacer with the Mounting Point.
D
(
)
Place the Foot Rails (Item 9) onto the Spacers, lining up the
holes in the base of the Foot Rails with the center of the
Spacers. The Product Sticker goes to the front of the vehicle
and must face outwards.
Secure the Foot Rails to the vehicle using the M8 x 40 Hex
Bolts, M8 Spring Washers and M8 x 19 Flat Washers (Items
2, 3, 4). Once fastened, place a M8 Nut Cap (Item 1) over the
head of each bolt.
REV_A02
Mark 2
Mark1
375 mm
240 mm
Mark 3
1245 mm
Locate Mounting Points and remove Tape
Front
3
Mark 4
1410 mm
Rear
Publicidad
