SNOWJOE 24V-SS13-CT Manual Del Operador página 12

2. Remove the belt from the drive wheel (Fig. 12).
Fig. 12
3. Remove the screws, the washers, and the bushings from
the drive wheel (Fig. 13).
Fig. 13
Bushing
4. Disassemble the right side cover by removing the five (5)
screws that hold it in place (Fig. 14).
Fig. 14
Right side cover
5. Use one hand to secure the auger, at the same time, use
the other hand to remove the auger assembly nut on the
right side. (Fig. 15).
Belt
6. From the left side, remove the auger axle set (Fig. 16).
Drive wheel
7. Remove the old auger from the housing (Fig. 17).
Washer Screw
8. Install the replacement auger by following the above steps
12
Fig. 15
Auger
assembly nut
Fig. 16
Fig. 17
in reverse order (Fig. 18).
Fig. 18
Auger axle set
Auger