Technical Specifications - Velleman SOL5N Manual Del Usuario

3. Operation
• Attach the suction caps to the charger and attach the charger to the inside or outside
of the car windshield.
• Alternatively, you can mount the charger to a wall using the keyhole slots at the rear
of the charger.
• Connect the cable to either the cigarette lighter or directly to the battery.
• As long as there is sufficient sunlight, the charger will produce a small electrical
current to trickle charge your battery. The red LED (#4 in above figure) will flash
when the panel is trickle charging the battery.
• The charger will not overcharge or damage the battery. Similarly, a blocking diode
ensures that the charger cannot flatten your battery.
• Please note that the SOL5N is designed to trickle charge batteries to compensate for
the natural drainage. It is not intended to recharge a completely discharged battery.
• Disconnect the charger before starting the car or driving it. The electrical surges from
the car engine may damage the charger.
• Some vehicles have tinted windows that seriously affect the performance of the solar
charger if it is positioned behind them. For optimum results, place the SOL5N outside
the vehicle in direct sunlight.

4. Technical Specifications

Power
Voltage Input
Nominal Voltage
Current
Dimensions
Weight
Tested under standard conditions: AM1.5, 100mW/c m², module at 25°C.
Refer to the Velleman® Service and Quality Warranty on the last pages of this
manual.
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use of
this device. For more info concerning this product, please visit our website
www.velleman.eu. The information in this manual is subject to change without
prior notice.
SOL5N
1.5W max.
12V (± 20%)
17.5V
125mA max.
340 x 120 x 14mm
0.45kg
- 3 -
®
VELLEMAN