VelLight LAMPH10S Manual Del Usuario página 2

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Vellight! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions

Always disconnect mains power when device not in use or when servicing or maintenance activities
are performed. Handle the power cord by the plug only.

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.

Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.

There are no user-serviceable parts inside the device. Refer to an authorized dealer for service
and/or spare parts.

Have the device repaired by a qualified person.
3. Assembly
1. Make sure the cable is disconnected from the power socket.
2. Remove the lamp cover.
3. Carefully screw the bulb (not included) into the socket.
The bulb must not exceed the specified wattage on the label (see Technical Specifications).
4. Screw the lamp cover tightly.
5. Insert the plug into the power socket and switch on the lamp.
4. Technical Specifications
socket ............................................................................................................ E27
maximum power ............................................................................................ 20 W
IP rating ........................................................................................................... 65
Class 2
dimensions
cable length ............................................................................................... 3 m
lamp diffuser ................................................................................ Ø 27 x 23 cm
steel base............................................................................................ Ø 23 cm
height .................................................................................................... 52 cm
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 01/12/2015
LAMPH10S
USER MANUAL
2 ©Velleman nv