Philips GC4937 Manual Del Usuario página 6

ENGLISH
10
Problem
Water droplets drips
onto the garment
during ironing.
The iron does not
produce a steam
boost.
Dirty water and
impurities come
out of the soleplate
during ironing.
Water drips from
the soleplate after
the iron has been
unplugged.
There is an amber
light flashing on the
handle of the iron.
The iron leaves a
shine or an imprint on
the garment.
Possible cause
The iron is not hot enough yet
to product steam.
You have used the steam
boost function too often
within a short period.
You have not closed the water
tank lid properly.
You have not insert the
Quick Calc Release collector
properly back to the appliance
(specific types only).
You have used the steam
boost function too often
within a short period.
The iron is not hot enough for
ironing yet.
You have put a chemical into
the water tank.
Hard water with impurities or
chemicals has formed flakes
inside the soleplate.
You have put the iron in
horizontal position with water
still left in the water tank.
The steam slider is set to
The Calc-Clean reminder light
is activated. This is to remind
you to perform calc clean.
The surface to be ironed was
uneven, for instance because
you ironed over a seam or a
fold in the garment.
Solution
Wait until the 'iron ready' light has
stopped breathing and lights up steadily.
Continue ironing in horizontal position
and wait a while before you use the
steam boost function again.
Press the lid until you hear a 'click' .
Stop ironing and let the iron cools down
for at least 1 hour. Take out the Quick
Calc Release collector. Insert it back into
the appliance and ensure the collector is
in-line with the surface of the appliance.
Push down the lever ("click").
If the Quick Calc Release collector is
damaged, contact a consumer care
center in your country (see the world wide
guarantee leaflet for contact details).
Continue ironing in horizontal position
and wait a while before you use the
steam boost function again.
Wait until the 'iron ready' light has
stopped breathing and lights up steadily.
Rinse the water tank and do not put any
perfume or chemicals into the water tank.
Perform Quick Calc Release (specific
types only) or Calc-Clean (specific types
only).
See chapter "Cleaning and maintenance".
Empty the water tank after use, or store
the iron in vertical position.
. Set the steam slider to
Perform Quick Calc Release (specific
types only) or Calc-Clean (specific
types only). See chapter "Cleaning and
maintenance".
The iron is safe to use on all ironable
garments. The shine or imprint is not
permanent and disappears when you
wash the garment. Avoid ironing over
seams or folds. You can also place a
cotton cloth over the area to be ironed to
avoid imprints.
.