Luminus NLKIDS Manual De Instrucciones página 12

1. Rear button
2. Programming indicator light
3. Charging indicator light
4. Charging port
Operation
Before use, charge the night light using the USB C charging cable. You can connect it to any
compatible USB charging source. The LED charging indicator light (3) will slowly blink red
while charging. The LED light will go off once the charging is complete.
1. Press and hold the rear button (1) for 3 seconds to switch the light on/off.
2. Turn the rear button (1) clockwise to increase the brightness, and counter-clockwise to
reduce the brightness.
3. Briefly press the rear button to start the timer
• 1 press - 15-minute timer - 1 LED indicator light illuminated
• 2 presses - 30-minute timer - 2 LED indicator lights illuminated
• 3 presses - 60-minute timer - 3 LED indicator lights illuminated
• 4 presses - Return to a 15-minute timer and restarts the cycle, as above.
The LED battery level indicator light is located next to the USB C port.
• The indicator light is green when the battery level is above 50%.
• The indicator light is red when the battery level is between 50% and 15%.
• The indicator light quickly blinks red when the battery level is below 15%.
• The indicator light goes off when the battery is empty.
Appliance technical specifications
Type
Energy
consumption
Battery capacity
Battery power
In an environment with electrostatic discharge, the device may turn off. The user must
then recharge the battery and reset the device.
Specifications
2 W (max.)
400 mAh
3.7 V, 400 mAh, 1.48 Wh Operating time
Type
Charging power
supply
Charging time
- EN 12 -
Specifications
DC 5 V, 1 A
2-3 hours
9 to 10 hours at 50%
brightness