Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Periodically check the brush cutter for misalignment,
binding of moving parts, breakage of parts and any other
condition that may affect the brush cutter operation. If
damaged, have the unit repaired before use.
Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
All maintenance, repair and inspection work should be
performed by an authorized service center.
Maintenance Chart
Refer to the following table for routine maintenance.
Requirements
Actions
Visual inspection
Cutting
Inspect and
System
check assembly
Check
All accessible
fasteners
Retighten
Troubleshooting
The following chart lists problems, causes and corrective
actions if your brush cutter does not operate properly. If
these do not correct the problem, contact an authorized
service center.
Problem
Motor runs but
blades remain
stationary
Cutting tool too hot
Excessive vibration
After
Before
start
finish
•
•
•
•
•
•
Possible Cause
Drive cables not engaged.
Dull cutting blades.
Loose fasteners.
Correction
Disconnect the poles; make sure the drive cables engage
as poles are connected.
Replace the blade assembly.
Tighten fasteners.
en
5
Publicidad
