Publicidad
Idiomas disponibles
Idiomas disponibles
10. Hold the chain and bar.
13
15
14
11. Put the chain loop around the sprocket (13).
12. Make sure the chain tension pin hole (14) on the
guide bar fits correctly with the bolt (15).
13. Install the chain cover.
14. Tighten the chain. Refer to Adjust the chain
tension.
15. Tighten the knob when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after
the first use, examine the tension and tighten the
chain if necessary.
10.2
ADJUST THE CHAIN TENSION
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take
up the slack.
Tension the chain so that it can only just be pulled
away from the bar at its center point.
During normal saw operation, the temperature of
the chain increases. The drive links of a correctly
tensioned warm chain will hang approximately 1/16
in. (1.58 mm) out of the bar groove.
1/16 in. (1.58 mm)
WARNING
A slack chain may jump off and cause serious or
even fatal injury.
English
NOTE
NOTE
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1.
Switch off the machine.
2.
Remove the battery pack.
3.
Raise the handle (12) of the chain cover knob (8).
4.
Loosen the chain cover (7) by turning the chain
cover knob (8) counterclockwise.
12 8
It is not necessary to remove the chain cover to
adjust the chain tension.
5.
Turn the chain tension knob (16) clockwise
to increase the chain tension or turn
counterclockwise to decrease the chain tension.
16
6.
Pull the chain in the middle of the guide bar at the
bottom away from the bar, the gap between the
chain guide and the guide bar should be between
3 mm and 6 mm.
7.
When the chain is at the wanted tension, tighten
the chain cover knob.
10.3
SHARPEN THE CUTTERS
Sharpen the cutters if chain does not go into wood
easily.
11
CAUTION
7
NOTE
3-6 mm
EN
Publicidad
