Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
11. This heater draws 12.5 amps during operation. To prevent overloading
a circuit, do not plug the heater into a circuit that already has other
appliances working.
12. The output of this heater may vary and its temperature may become
intense enough to burn exposed skin. Use of this heater is not
recommended for persons with reduced sensitivity to heat or an inability
to react to avoid burns.
13. Don't leave the heater on unattended.
CAUTION: Always plug heaters directly into a wall outlet/receptacle.
Never use with an extension cord or relocatable power tap
(outlet/power strip).
SAVE THESE INSTRUCTIONS
ELECTRICAL REQUIREMENTS
In the event of malfunction or insulation breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. The appliance must be
connected to a cord having an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DANGER: Improper connection of the equipment grounding conductor can result
in a risk of electric shock. The conductor with insulation having an outer surface that is
green with or without yellow stripes is the equipment grounding conductor. If repair or
replacement of the cord or plug is necessary, do not connect the equipment-grounding
conductor to a live terminal. Check with a qualified electrician or service person if the
grounding instructions are not completely understood, or if in doubt as to whether the
appliance is properly grounded. Do not modify the plug connected to the appliance – if it will
not fit the outlet, have a proper outlet installed by a qualified electrician.
FOR GROUNDED, CORD-CONNECTED APPLIANCE RATED LESS THAN 15A AND INTENDED
FOR USE ON A NOMINAL 120V SUPPLY CIRCUIT
The appliance is for use on a nominal 120V circuit, and should be connected to a grounding
outlet as illustrated in sketch A. A temporary adaptor, as illustrated in sketch C, may be used
to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded
outlet is not available. The temporary adaptor should only be used until a properly grounded
outlet can be installed by a qualified electrician. The green colored rigid ear, lug, and the like,
extending from the adaptor must be connected to a permanent ground such as a properly
grounded outlet box cover. Whenever the adaptor is used, it must be held in place by the
metal screw.
Page 4
HOUSEHOLD USE ONLY
Publicidad
