Publicidad
electrical circuit with a rated residual current not exceeding 30 mA. Please consult an
electrician for this.
15. It is forbidden to insert fingers or any other objects into openings in the device casing.
16. Do not cover the discharge opening.
17. After finishing work, empty the device of water before storing it away.
18. If the device will not be used for a long time, disconnect it from the mains.
19. Do not move the machine when there is water in the internal tank.
20. Do not place any objects on the device.
21. The device should only be used with recommended fragrances. The use of other
substances may result in a toxic or fire hazard.
22. The device may only be used with efficient ventilation.
23. An unusual smell, noise, or abnormal heating indicates a product or power adapter
failure, immediately remove the power adapter from the wall outlet and stop using the
device.
24. Please do not put the adapter in water or use it when it is wet. Do not store the power
supply in a damp place.
BEFORE FIRST USE
1.Keep in mind that high humidity levels can encourage the growth of biological organisms in the environment.
2. Do not allow the area around the device to become damp or wet. If moisture occurs, lower (reduce) the mist output. Do not allow
absorbent materials such as carpets, curtains, tablecloths to get wet.
3. Place this device on a flat surface. Do not place this product on a carpet, rug or other uneven place.
4. Do not place this device near electrical appliances such as TV or sound equipment, etc. Do not let it splash directly on furniture, clothes
or walls, etc.
PRINCIPLE OF OPERATION
Through the ultrasonic wave, the diffuser breaks the water and essential oil into tiny particles a cold mist diffuses a fresh aroma.
WHICH OIL TO CHOOSE?
This aroma diffuser requires the use of water. There are no restrictions on what kind of oil is added to the water, both essential oil/aroma
oil/complex oils / fragrance water are suitable for use.
PRODUCT DESCRIPTION: Aroma Diffuser CR 7970
A. Spray nozzle
E. Water tank
H. Air inlet
USE
Place the device in the place of intended use and do not move it during use.
1. Hold the product upright and remove the top cover (B) vertically. (Fig.1)
2. Connect the DC plug of the power adapter to the DC connector of the device (I). (Fig.2)
B. Top cover
C. Inner cover
F. Housing
G1. Spray button "MIST
I. DC connector
J. Drain hole
6
D. Air outlet
G2. Blacklight button "LIGHT"
K. Chip spraying ultrasonic waves
Publicidad
