Descargar Imprimir esta página

Trust ZSDR-850 Manual De Instrucciones página 6

Ocultar thumbs Ver también para ZSDR-850:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
EN
ZSDR-850 SMOKE DETECTOR
COMPATIBILITY
This photoelectric smoke detector works with the Smart
Bridge and the ICS-2000 to give additional functionality
like receiving push notifications when smoke is detected.
NOTE: For receiving push notifications, a fully working
internet connection is required.
PLACING THE SMOKE DETECTOR
• Place the detector on the ceiling. In case of a sloped
ceiling, place 90 cm from the highest point.
• To ensure that the sound can be clearly heard in
bedrooms, the smoke detector must be placed no further
than 3 meters from a bedroom door.
• It is recommended to install a smoke detector on every
floor of your home
• Place the detector at least 2m away from cooking
appliances
• Relocate the unit if it produces frequent false alarms
• Do not place the smoke detector near exhaust fans or
air-conditioning systems as they can prevent smoke from
reaching the smoke detector
• Avoid placing the detector in bathrooms and other very
humid or dusty places
• Always comply with the local regulations for installation
in buildings.
6
TESTING AND USAGE
• Always test the detector using the test mode after
placement and after that once a week.
• Test the detector once a week. Replace the detector
immediately when the test fails.
• Replace the battery immediately when the detector is
indicating battery low. (up to 3-year battery life)
• Clean the detector once a month with a soft brush
• Never use water, cleaners or solvents to clean the
detector since they may damage the unit.
• If the detector is damaged replace it immediately.
• The smoke detector will not alert hearing impaired
residents. It is recommended to install special smoke
detectors to alert hearing impaired residents.
• Never use an open flame of any kind to test this unit.
You might accidentally damage or set fire to the unit or
to your home.
• Use only a CR123A 3.0V Lithium Battery. Other batteries
may cause unreliable operation.
• Removal of the battery will render this alarm inoperative
• Press test button to check operation after replacing the
battery.
Check www.trust.com/71197 for the latest instructions

Publicidad

loading

Este manual también es adecuado para:

71197