Husqvarna PS 300C Manual De Usuario página 5

To assemble the battery charger
1. Make sure that the power plug (A) is not connected
to a mains socket.
C
B
To charge the battery
CAUTION:
in conditions where the temperature is
between 0 °C (32 °F) and 40 °C (104 °F).
CAUTION:
in a location that has a good airflow.
1. Make sure that the charger ON/OFF switch is set to
OFF.
2. Connect the power plug to a grounded mains socket.
CAUTION:
charger to a mains socket that has the
2011 - 001 - 11.04.2023
Assembly
A
Operation
Use the battery charger
Only use the battery charger
Only connect the battery
2. Connect the power cord (B) to the power socket (C)
on the battery charger.
voltage and frequency specified on the
rating plate.
3. Connect the charger plug to the socket for the
battery charger on the product.
4. Set the charger ON/OFF switch to ON. If possible,
make sure that the product shows that the battery
charges.
Note:
For the location of the charge indicator, refer
to the Operator's manual for the product.
5. Set the charger ON/OFF switch to OFF when the
battery is fully charged. For charge times, refer to the
Operator's manual for the product.
6. Disconnect the charger plug from the socket for the
battery charger on the product.
7. Pull the power plug to disconnect the battery charger
from the mains socket. Do not pull the power cord.
5