LD Systems STINGER G3 Serie Manual De Usuario página 5

Sporting lightweight Class D power stages, active Stinger
ture up to a massive 500 watts RMS output and carefully tailored presets for flat response, fullrange, satellite or floor monitor applications.
LD Systems' proprietary DynX ® DSP technology ensures perfect time alignment and distortion-free performance even at maximum levels.
Producing tremendous low end punch and definition with up to 800 watts RMS output power, Stinger
presets for rapid system integration and cardioid array configurations.
All Stinger G3 enclosures are made of rigid, low-resonance birch ply. They are coated with non-abrasive, impact resistant polyurea
®
for superior strength and unrivaled durability. Integrating LD Systems' Dual-Tilt pole mount, multiple suspension points, stacking
recesses and ergonomic handles the Stinger
applications. The large selection of Stinger
board to facilitate transport. Isn't it time you saddled up?
CONNECTIONS, CONTROLS AND INDICATORS
INPUT LINE / MIC CH 1 & 2
1
Balanced microphone or line input (XLR / 6.3 mm jack combo) for channels 1 and 2 (CH 1 + CH 2). It is also possible to use unbalanced
microphone cables (Mono jack). Switching to the corresponding setting is done using the MIC / LINE N 3 switch.
GAIN CH 1 & 2
2
Volume controller for channels 1 and 2 (CH 1 + CH 2). Turning the controller to the left decreases the volume; turning it to the right increases it.
LINE / MIC
3
Switch for switching the input impedance and the signal boost for channels 1 and 2 (CH 1 + CH 2). Please set the volume controller of the correspond-
ing channel to minimum (left stop) before connecting a playback device or microphone. To connect a playback device with a line level (e.g. mixer,
keyboard), select the LINE setting (LED indicator MIC is not lit); to connect a microphone, select the MIC setting (LED indicator MIC is lit).
MODE
4
Switch to switch between DSP presets. The different presets are retrieved by repeatedly pressing the switch (check the LED indicator).
FULL-RANGE: Preset for operating the loudspeaker without any additional subwoofer (bass boost, presence cut and treble boost).
SATELLITE: Optimal setting for operating with a subwoofer (high-pass filter at 90 hertz, presence cutback and treble boost).
MONITOR: Preset for operating the speaker as a stage monitor (bass cutback to compensate for ground coupling,
treble cutback for optimum, prominent sound at close range).
FLAT: Linear frequency response in DSP preset when using an external equaliser for manual adjustment to the sound situation at hand.
G3 models are capable of huge sound pressure levels. The multi-purpose tops fea-
®
G3 Series has been designed for touring musicians, rental companies and installation
®
accessories includes smart wall and truss mounting hardware plus a stackable dolly
®
4
5
3 3
2 2
1 1
6
G3 subwoofers include user-friendly
®
8
7
5