Troubleshooting - Surtek RM740 Manual De Usuario Y Garantía

CAUTION: Don't use chemical agents as
petroleum, solvents or similar products to clean
the tool.
WARNING: Use only accessories that are
recommended by the manufacturer for your
model. Accessories that may be suitable for one
tool may become hazardous when used with
another tool.
WARNING: Maintain tools with care. Keep
cutting tools sharp and clean.
WARNING: Check extension cords before
each use. If damaged, replace immediately. Nev-
er use tool with a damaged cord.

TROUBLESHOOTING

MOTOR STOPS RUNNING
Unconnected to power source. Connect to pow-
er source.
Plugs not fully connect. Check all plugs.
Switch out of work. Replace or repair the switch.
Brushes not touch the commutator. Replace the
brush with a new one.
DRILL BIT DOESN'T ROTATE
Operating mode selector knob not engaged.
After rotation has stopped, move the operating
mode selector knob until it engages.
NO HAMMERING ACTION AND THE TOOL WOB-
BLES
The tools is too cold. Allow tool to reach the
minimum operating temperature.
Operating mode selector knob set to rotary
drilling. Set operating mode selector knob to
hammer drilling.
TOOL DOESN'T PRODUCE FULL POWER
Control switch is not pressed fully. Press the
control switch as far as it will go.
E N G L I S H •
Us er 's M an u a l
13