Agio WT17YL1 Manual De Instrucciones página 11

PROBLEM
Burner Won't Light
Burner won't stay
lit after lighting
AUSTRALIA: Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
TROUBLESHOOTING GUIDE
CAUSE
No propane gas at burner
No spark at electrode
Lack of oxygen
Thermocouple not in
Flame
Thermocouple connection
at the main control valve is
loose.
No fire ice on burner
REMEDY
Check that the gas tank valve is open.
Turn the control knob to "ON" and push
the control knob in. Make sure the tank
has propane gas.
Check that the AA battery is installed
with the negative (-) end first and has a
charge. Check that the wire is
connected to the ignition module.
Check that the electrode is not cracked
or broken.
Remove excess lava rocks or fire ice
from around the ignition well.
Check that the tip of the thermocouple
is even with the top of the ignition well.
Remove any fire ice from the ignition
well.
Tighten the thermocouple nut at the
back of the valve.
Cover the burner with fire ice per the
instructions.
11