Blaupunkt 5DS99770 Instrucciones De Uso página 11

4. CONTROLS
Button Function
A Press and hold for approximately 1 second to turn the
hood on/off at speed 1.
B Press the "-" symbol and swipe your finger towards
the "+" symbol:
swipe once = speed 1
swipe twice = speed 2
swipe three times = speed 3
swipe four times = Intensive speed.
Intensive speed is timed to run for 6 minutes. At the
end of this time the system will return to the speed
set previously.
Repeat the operation in the opposite direction to
decrease the speed (from the "+" symbol to the "-"
symbol).
Press briefly to activate/deactivate Delay mode, causing
automatic shutdown of the Motor and the Lighting
system after 30 minutes. This mode cannot be activated
if Intensive or 24h modes are active.
C
Press the same button to deactivate the function or
press and hold button A for approximately 1 second
to turn the motor off.
D Press briefly to activate/deactivate 24h mode.
This mode turns the motor on at speed 1 for 10 minutes
every hour. This mode cannot be activated if Intensive
or Delay modes are active.
Press the same button to deactivate the function or
press and hold button A for approximately 1 second
to turn the motor off.
E
Press briefly to turn the lighting system on and off at
maximum intensity.
Press and hold the button for approximately 1 second,
with all the loads turned off (Motor and Lights), to reset
the alarm when the filter alarm is triggered.
F Press briefly to turn the lighting system on and off at
medium intensity.
Press and hold the button for approximately 1 second,
with all the loads turned off (Motor and Lights), to
enable/disable the charcoal filters alarm.
G With the motor turned off: press briefly, to activate/
deactivate the button pad lock to allow cleaning of
the hood.
Display/Led
The display indicates 1.
The display indicates the selected speed.
The display shows an animation when Intensive
speed is selected.
Led A remains fixed and led C lights up. The display
shows an animation.
Function activated: the display shows an animation
and led D flashes every 0.5 seconds.
Led E lights up.
The display indicates F 3 times, showing that the filter
reset has been completed.
Metal grease filters: the alarm is triggered after the
Hood has been in operation for 100 working hours.
With the motor turned off: the display indicates F + 1
alternately several times.
Activated charcoal filters: the alarm is triggered after
the Hood has been in operation for 200 working hours.
With the motor turned off: the display indicates F + 2
alternately several times.
If both the alarms are active, the display will indicate
F + 1 and F + 2 alternately several times.
Led F lights up.
Filters alarm enabled: the display indicates F + 2
Filters alarm disabled: the display indicates F + 0
Led G remains fixed while the other leds flash.
11