ulsonix FLOORCLEAN 80VO PRO Manual De Instrucciones página 13

Before starting work, make sure that:
• A filter is installed in the appliance.
• The clips securing the head to the tank are tight.
• The wheels are fixed in the holes in the base of the unit.
3.4. Working with the device
Connect the hose to the socket and equip it with a suitable fitting.
Connect the vacuum cleaner to the power supply.
Start the vacuum cleaner with the main ON / OFF switches setting the desired power level (2000W for
FLOORCLEAN 80VO PRO, 3000W for FLOORCLEAN 100VO PRO).
Start vacuuming.
After finishing work with the vacuum cleaner, you should:
Turn off the vacuum cleaner with the main ON/OFF switches.
•
Disconnect the vacuum cleaner from the power supply.
•
Disconnect the hose, tube, and tube end from the vacuum cleaner. Clean these items.
•
• Unfasten the clamps and remove the upper part of the vacuum cleaner.
• Remove, wash and dry the filter. Wash the filter with warm water.
• Clean the tank with a soft cloth.
When the suction power weakens, do the following to restore power:
Plug the suction opening with your hand or block the suction hose while the machine is running.
Press the dust-shake button approximately 5 times as shown:
If the suction power does not return to normal after this operation, clean the filter and dust container.
3.5. Cleaning and maintenance
a) Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.