Publicidad
Idiomas disponibles
Idiomas disponibles
Care and cleaning of the dispenser.
Drain
outlet cap
(rear of dispenser)
To remove
To replace
Support
collar
Separator
6
Draining the Dispenser
The dispenser should be drained before cleaning
the tanks and before leaving for long vacations or
absences.
1. Set both power switches (on the back of
the dispenser) in the O (off) position and
unplug the dispenser.
2. Remove the water bottle from the
dispenser.
3. Put a container that will withstand hot
water under the hot water tap. Press the
hot dispenser button until the water is cool
(about 1 quart). Add water to the cold
water reservoir (on top where the bottle
supplies water) as needed.
4. Dispense water from both buttons into
container(s) until no more water can be
dispensed (about 1 quart of water still
remains in the dispenser).
5. Place a large bucket beneath the drain
outlet on the rear of the dispenser.
Cleaning the Separator
IMPORTANT: Set both power switches (on the
back of the dispenser) in the O (off) position and
unplug the water dispenser before cleaning.
1. Remove the water bottle and drain the
dispenser (see Draining the Dispenser).
2. Remove the support collar by turning
counterclockwise and pulling straight off.
3. Remove the plastic separator by pulling
straight out (you may need to twist slightly
to loosen).
4. Clean the separator with dish soap and
water or in the top rack of the dishwasher.
6. Using a Phillips screwdriver, loosen the
screws on the bracket covering the drain
outlet cap. Rotate the bracket out of the
way to allow access to the cap.
7. Remove the cap and silicon stopper from
the drain outlet and and allow water to
drain. After draining, replace the stopper
and cap.
8. Rotate the bracket back into place and
tighten screws.
Make sure to install a full bottle and
dispense water from the hot water tap before
plugging in and turning on the dispenser
(see Loading the Dispenser).
5. Dry the separator thoroughly on both
sides.
6. Using a clean cloth or paper towel,
thoroughly dry the cold water reservoir.
7. Place the separator back in the dispenser.
Make sure the long, tapered end of the
separator is positioned firmly on the metal
plug on the bottom of the reservoir.
8. Replace the support collar and turn
clockwise until it is firmly in place.
9. Install a full water bottle on the dispenser
(see Loading the Dispenser).
Publicidad
