Genesis GLID20A Manual Del Operario página 6

Always hold the tool firmly in your hands
•
the torque of the motor as it accelerates to full speed may cause the tool to twist.
Wear eye and hearing protection
•
otherwise specified, everyday glasses provide only limited impact resistance, they are not safety glasses.
use only certified safety equipment; eye protection equipment should comply with ANSI z87.1 standards.
Protective hearing equipment should comply with ANSI s3.19
Bits, sockets and tool get hot during operation.
•
Protect your lungs. Wear a face or dust mask
•
will reduce the risk of personal injury.
Always disconnect battery pack from tool
•
before any assembly, adjustments or changing of accessories. following this instruction will reduce the risk
of serious personal injury.
Do not place battery tools or their batteries near fire or heat
•
risk of explosion and
Never use a battery which has been dropped or received a sharp blow.
•
damaged battery is subject to explosion. Properly dispose of a dropped or damaged battery immediately.
Use designated battery pack (Genesis™ -Model GLAB20A) and charger
•
(Genesis™- Model GLACH20AS) for this tool.
risk of fire.
WArNING:
designated battery and charger before using this tool. This manual contains important
safety and operating instruction for battery charger.
SAVE THESE INSTRUCTIONS
IMPOrTANT SAFETY INSTrUCTIONS FOr CHArGEr &
BATTErY
Save These Instructions.
•
your battery charger.
Before Using the battery Charger,
•
Charger, (2) Battery, and (3) Product using battery.
Use only the charger
•
manual. Do not substitute any other charger.
Do not recharge battery in damp or wet environments
•
water or rain.
Do not operate charger with damaged cord or plug
•
Do not operate charger if it has received a sharp blow,
•
damaged in any way. Take it to a qualified serviceman.
Do not disassemble charger or battery pack.
•
service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
Do not charge battery pack
•
104 degrees f (40 degrees C). Store tool and battery pack in a location where temperature will not exceed
122 degrees f (50 degree C). This is important to prevent serious damage to the battery cells.
Place charger on flat non-flammable surface
•
re-charging the battery pack.
To reduce risk of electric shock,
•
maintenance or cleaning.
f operating time has become excessively shorter,
• I
result in a risk of overheating, possible burns and even an explosion.
20V Lithium-Ion Impact Driver
Operator's Manual
. Always use safety glasses with side shields. unless
possibly personal injury.
read and understand safety and operating instructions of
This manual contains important safety and operating instructions for
which accompanied your product or direct replacements as listed in this
when temperature is below 50 degrees f (10 degrees C) or above
unplug charger from outlet before attempting any
before switching the tool "ON". The reaction to
standards.
Wear gloves when touching them.
if the operation is dusty. following this rule
or place the switch in the locked or off position
use of any other batteries may result in a
read all instructions and cautionary markings on (1) Battery
. Replace immediately.
Take it to a qualified serviceman when
and away from flammable materials when
stop operating immediately. It may
GLID20A
reduce the
. This will
A
. Do not expose battery pack to
been dropped or otherwise