Beckett C90211 Manual De Instrucciones página 2

HELPFUL SITE PLANNING HINTS
Waterfalls generally face the viewing area.
When building your Waterfall, keep in mind you will
need room for easy access to the Waterfall for
maintenance.
STEP 1:
Place the Hose Clamp over one end of the
Tubing.
STEP 2:
Attach the Tubing to the Adapter located at the
Waterfall's underside and tighten the Clamp to seal.
STEP 3:
Attach the other end of the Tubing to the
Pump.
STEP 4
: Place the Bio-Filter Foam in the bottom of the
Waterfall.
STEP 5:
Place your Lava Rock inside the Mesh Bag
and lay flat on top of the Bio-Filter Foam to prevent the
Foam from floating.
STEP 6:
Build a mound with dirt or stones for your
Waterfall to your desired height.
STEP 7:
Drape the Liner over the mound, including the
back of the mound.
STEP 8:
Place the Waterfall on top of the mound.
STEP 9:
Secure the mound and Waterfall with flat rocks
or bricks. Create a lip with the liner to drain possible leaks
back into the pond
STEP 10:
Place the Pump in the pond.
STEP 11:
Bury the Tubing.
STEP 12:
Fill the Pond with water.
STEP 13:
Read the following information about the
Pump, then plug the Pump into a GFCI receptacle.
STEP 14:
Enjoy your Waterfall!
Primary
Viewing
Area
GFCI
Mesh Bag
Lava Rock (Not Included)
Bio-Filter Foam
Waterfall
Clamp
Tubing
Pump
PVC Liner
Pond
Waterfall
Mound
of Dirt
-2-