Descargar Imprimir esta página

TREVIDEA GIRMI ST03 Manual Del Uso página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
GENERAL INFORMATION
At first use, remove the protective film of the plate; due to
the presence of a protective oil and residues left over from
the film, the plate could emit some smoke. After few
uses, the smoke will disappear.
When using the product for the first time, repeatedly use
the steam (away from clothes) and try to use the iron on a
worthless piece of cloth to remove any manufacturing
residues that may stain or scratch the fabric.
Thoroughly dry the clothes before iron them, do not iron
over buttons and zippers.
When not using the ironing system or during breaks,
always store the iron on the appropriate insulated rubber
placed on tank and make sure it is stable. Do not leave
product unattended when the plate is hot.
Keep the cord free from knots and tangles. Do not wrap
the power cord around the iron, either before or after use,
or place it closer to the iron plate when it is hot.
Do not pull the cord to unplug the unit.
When inside the boiler there is a pressure such as to
produce steam, do not screw the cap off. Only when the
pressure decreases, the cap can be opened.
CAUTION: if you wish to open the tank, wait few
minutes and then unscrew the cap slowly to slowly
release the remaining steam from the tank until
exhausting
Do not use the ironing system as a heating unit.
Unplug the appliance before you fill or empty the tank.
We recommend the use of distilled water to avoid
excessive fouling (not covered by warranty).
Do not fill the tank above the maximum capacity and do
not introduce into the tank mixtures for removing stain,
vinegar, descaling agents or chemicals in general.
Always select the most suitable temperature according to
the fabric to be ironed.
12

Publicidad

loading

Este manual también es adecuado para:

Cea-yc738-a