TREVIDEA GIRMI SS65 Manual Del Uso página 14

release the remaining steam from the tank until
exhausting.
Do not use the ironing system as a heating unit.
Always unplug the iron before you fill or empty the tank
We recommend the use of distilled water to avoid
excessive fouling (not covered by warranty).
Do not fill the tank above the maximum capacity and do
not introduce into the tank mixtures for removing stain,
vinegar, descaling agents or chemicals in general.
Use the appropriate refill cup to fill the tank of the boiler;
do not fill it directly under the tap or with very cold
liquids.
Always select the most suitable temperature according to
the fabric to be ironed.
After ironing, drain all the water pushing the appropriate
release button, empty the tank and wait for the cooling of
all parts before storing the system.
CAUTION: the iron plate gets very hot during use, be
careful not to touch it, serious risk of burns. Do not
put your face near the steam coming out the iron plate
For correct closing of the boiler, press the cap while
rotating it.
DESCRIPTION SS65
(1) Main unit/boiler
(3) Control light: "Steam ready"
(5) Boiler power on button and working light
(7) Insulating rubber base
(9) Water level control light
(11) Continuous steam button
(13) Steam button
INSTALLATION
Place the ironing system on a stable surface, away from heat sources.
Unscrew the cap (15) and fill the tank using the appropriate dispenser without reaching the maximum
capacity of 1 liter. On first use, or after the iron has been unused for a long time, it is recommended to expel
the steam by pushing the button (13) for about 20 seconds. This procedure allows to eliminate any working or
limestone leftovers. For correct boiler closing, press the cap while rotating it.
(2) Pressure gauge
(4) Steam control knob
(6) Iron power on button and working light
(8) Steam cord
(10) Power cord and plug
(12) Temperature control knob
(14) Iron temperature control light (15) Cap
13