Publicidad
Idiomas disponibles
Idiomas disponibles
B
C
D
Assembly
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Attachment shaft assembly
1.
Plug charger AC cord in the wall outlet.
2.
Align ridges on battery with grooves on charger, and slide
battery into charger.
3.
During normal charging, the charger LED (B) will blink con-
tinuously GREEN.
If charger detects a problem, LED blinks RED. Remove bat-
tery from charger, clear obstructions from contacts and rein-
stall battery into charger. If battery is outside acceptable
temperature range (0°C to 60°C) LED remains RED.
A
4.
When charging is complete, LED will remain GREEN.
5.
Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button (C), and
checking LED display (D).
One green light indicates that the battery has 0-25%
charge.
Two green lights indicate that the battery has 25-50%
charge.
Three green lights indicate that the battery has 50-75%
charge.
Four green lights indicate that the battery has 75-100%
charge.
6.
Disconnect battery charger from power supply.
WARNING
1.
Set power head/shaft assembly on a level surface.
2.
Pull locator pin (A) out, and turn anticlockwise 1/4 turn to
lockout position.
3.
Remove vinyl cap from attachment drive shaft.
9
Before you start
IMPORTANT
Publicidad
