Publicidad
Idiomas disponibles
Idiomas disponibles
Keep the cord away from sharp edges and hot surfaces.
Do not place the appliance near gas or electric oven or store at heated surface.
The blades are very sharp, so handle them with care.
Do not push products into the appliance by fingers while it is in use.
If food becomes lodged in feeding tube, use pusher to push it down. If this doesn‟t work, turn the motor off, unplug the appliance and disassemble it to remove remaining food.
Do not carry the unit by the food tray or head. Be sure to hold the housing with both hands.
Do not operate after malfunction or damage of cord.
Do not grind hard food, such as bones, nuts, ginger or other products with hard fiber.
Do not operate for more than 5 minutes at one time. Turn off switch and let it rest for at least 10 minutes to cool down the motor, otherwise the motor may be damaged.
If in case of overloading the overheat protection system is activated, switch off the appliance by pressing the ON/O/R button to O position, unplug it, and let the appliance cool down about 60 minutes, and
then continue operation.
Do not attempt to repair, adjust or replace parts in the meat grinder. Repair the malfunctioning appliance in the nearest service center.
The grinder head may rotate slightly during the use, but it is normal.
Do not over tighten the fixing ring to stop the movement. It may cause damage.
Removable metal parts (screw, cutting knife, cutting plates) can be oxidized after use. It is normal.
BEFORE FIRST USE
Unpack your appliance. Remove all packing materials.
Check if all parts are in a set and not damaged.
Clean all the parts according to the article «Cleaning and maintenance». Do not immerse motor unit into water.
Dry thoroughly before use.
USING THE APPLIANCE
ASSEMBLING
1.
Press the locking button, hold the head and insert into the inlet. When inserting please make sure that head must be slanted as per arrow indicated (fig.1), then move the head anticlockwise so the
head will be fastened tightly. (fig.2)
2.
Place the feeder screw into the head, long end first, and turn to feed the screw slightly until it is set into the motor housing. (fig.3)
9
Publicidad
