Publicidad
Idiomas disponibles
Idiomas disponibles
hose is immersed under water.
• The motor is protected against overheating by an integrated thermostat. In the event of overheating,
the thermostat will automatically switch o the pump. The pump will automatically restart after it has
cooled down.
FR
Stop the pump
• To reduce the risk of injury, always stop the machine :
ES
- before cleaning or clearing a blockage
- before installing or removing attachments
PT
FR
Interface :
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect
IT
ES
immediately).
EL
PT
4.5 SPECIFIC FUNCTIONS
There is no speci c function about this product.
PL
IT
RU
EL
5. TRANSPORTATION
KZ
PL
5.1 TRANSPORT THE MACHINE
UA
RU
RO
KZ
Always lift and carry the pump with the carrying handle. Protect the product from any heavy impact
EN
UA
or strong vibrations which may occur during transportation in vehicles. If you want to transport the
appliance on a vehicle secure it from slipping or vibrating. Secure the product to prevent it from slipping
or falling over.
RO
6. WINTERING
EN
Illustration 5.1 to 5.3
Switch o and empty the pump.
Follow all instructions given on chapter storage below.
7. STORAGE
7.1 STORE THE MACHINE
The instructions mentioned in the maintenance section must be carried out before any storage.
Illustration 5.1 to 5.3
• Completely drain the pump, allow it to dry and put back the two connector caps.
• Clean the product, filters and accessories
• Store the unit and its accessories in a frost-free place.
• The unit should always be stored in a clean, dry, ventilated place out of the reach of children. Ideally, the
temperature of the room in which the device is stored should be between 4 and 24°C.
• We recommend that you store the unit in an upright position, in its original package.
• Power On : If lit, the pressure control unit has been powered and is ready for
operation. The pump is not running.
• Pump On : If lit, the pump is operating. A line of the discharged liquid is
opened.
• Failure : If lit, the pressure control has detected a fault. In that case, please refer
to "Troubleshooting" chapter.
• Restart : To restart the pump after resolving a failure, reset the pressure control
unit by pressing this button.
CAUTION In order to prevent accidents or injuries,
keep in mind the weight of the appliance during transport
(see Technical Data).
15
202
R
K
U
R
E
Publicidad
