Publicidad
Idiomas disponibles
Idiomas disponibles
Drill and fit rivnuts
A
(
)
Starting at the front of the vehicle's roof, measure and mark the distances as illustrated below onto each
of the ditch mouldings found on the left and right hand sides of the vehicle's roof.
Remove the two ditch mouldings and cut the mouldings on each of your markings. Make sure to mark the
various pieces so that you are able to place them back onto the vehicle in their correct positions at a later
stage. The four pieces each side, corresponding to the "Cut Out" markings on the image below may be
discarded.
FRONT OF VEHICLE
B
(
)
Make the following four markings as shown below in the center of each ditch in the vehicle's roof.
FRONT OF VEHICLE
REV_A01
3
REAR OF VEHICLE
REAR OF VEHICLE
Publicidad
