Publicidad
Idiomas disponibles
Idiomas disponibles
EN
LUBRICATION
> Before lubricating the
machine, always first disconnect
the power plug.
The demolition hammer has an
integrated oil tank. Before use,
check that the oil level is correct
(FIG. 7 and 8).
1. Keep the machine upright
with the toolholder face down
on the ground. If the level of oil
visible through the indicator is less
than 30 mm, fill the tank.
2. Use a cross head screwdriver
(not supplied) to unscrew the
access cover.
Be careful not to lose the rubber
gasket access cover.
3. Check the oil level before each
use to ensure that the machine is
properly lubricated during the work.
4. After filling, securely tighten
the indicator access cover.
5. Use oil - 15W40.
MAINTENANCE
> ATTENTION
For any maintenance on the
machine, it is compulsory
to disconnect the power plug.
Machine Inspection
The use of an used or blunted chisel
can cause malfunction of the engine
and reduce the efficiency.
Sharpen the chisels or replace them
if they are used.
Regularly inspect the screws
and make sure they are properly
tightened. If a screw is loosened,
tighten it immediately.
Failure to observe this information
may present a risk of serious injury.
Replacing carbon brushes
If brushes are worn, cracked
or if the length is less than 6 mm,
replace them with original brushes.
Always replace the brushes in pairs.
To access the brushes, remove
its covers (on each side of the
engine block).
Oil level checking
The breaker oil level should be
checked regularly for better
functioning (see the section
"Lubrication").
Oil change
The oil should be replaced after
approx. 40-50 hours of use.
Unscrew the access cover (6)
with a cross head screwdriver
(not supplied) and drain the oil.
So that the oil does not flow
uncontrollably, hold one funnel
below and collect the oil in a
container until it has passed
through.
NOTE: Used oil is a major
source of pollution of our
environment, so it is highly
recommended to bring it in an
airtight container at a service
station or a waste sorting unit.
Do not throw away the oil with
domestic waste, do not lie on
the ground, in sewers or in
rainwater pipes.
Fill the reservoir (approx.
70-80 ml) of oil through the filling
opening (6).
The oil level should reach the
required level. Firmly retighten the
access cover.
After a brief period of use,
the oil level should be checked
again.
Cleaning certain parts
When the breaker has been used
for some time, dust or other
substances can prevent proper
operation of the device.
You can then clean and lubricate
the device.
Frequently check your device.
Pay attention to any problem that
might occur with the power cord,
plug, switch...
The engine is the main element
of the hammer. It is important that
it is not damaged, and that is free
of grease and moisture.
After each use, use compressed
air to blow the dust from vents
(wear safety glasses for this
operation).
Spare parts
Defective parts must be replaced
with original spare parts by an
authorized company.
STORAGE
1. Always store your hammer
in a dry place and out of reach
of children.
2. Always keep the breaker
in a horizontal position.
3. Keep air vents clean and free
from debris. If necessary,
use compressed air to blow the dust
accumulated into the slots (to do
this, use safety glasses).
4. Keep the housing clean and
grease-free. Never use water,
21
Publicidad
