Publicidad
Idiomas disponibles
Idiomas disponibles
DIRECTIONS FOR USE
SET Up
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
1. Separate the tank from the base
of the unit.
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the tank.
5. Attach the tank to the base of the
unit and plug adapter into port on
lower back of unit. Plug into power
outlet.
E-6
2. Flip over water tank and open the
tank lid, turning it to the left.
4. Close the tank lid, turning it to
the right.
6. Turn dial to power on and adjust
to preferred mist.
• Green LED will illuminate when running.
• Red LED indicates the unit needs refilling.
DIRECTIONS FOR USE
• Always unplug the unit before servicing it in any way.
• Do not submerse the unit in water, or allow water to enter the inside of the unit.
CLEANING
• Always unplug the unit before servicing in any way.
• The water temperature of the water remaining in the unit after use may be high, allow
time for it to cool.
GENERAL CLEANING
• Inside the base of the unit. Pour excess water out of the unit. Wash out the unit with fresh
water using the cleaning brush and a soft cloth as needed. Do not submerse the base of the
unit into water, or allow water to enter inside the dry air exhaust port of the unit.
• Water tank. Empty water tank. Remove mist nozzle and clean the mist tube with fresh water
and a light brush (bottle cleaning brush is recommended).
• Outer surface of the unit. Wipe the surface of the unit with a soft, damp cloth if needed. If
you notice an accumulation of water during usage, reduce humidity and dry outer surface with
a cloth.
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• If you live in a hardwater area, we recommend the use of distilled water for your
humidifier. This will help reduce the precipitation of minerals or 'white dust'.
• Do not clean the unit or water tank with detergents or cleaning chemicals of any kind.
ULTRASONIC DISk
1. Unplug unit.
2. Remove the tank and empty all water from unit base and tank.
3. Locate the ultrasonic disk on the inside center of the base unit. (Fig. 1)
4. Use ONLY the enclosed cleaning brush to gently clean disk and remove build up and deposits.
(Fig. 1) Do not scrub or scrape the ultrasonic disk.
(Fig. 1)
*Clean the disk with the
brush only. No other
cleaning tool should
be used. BRUSH ONLY.
(Fig. 1)
Ultrasonic Disk
E-7
Publicidad
