Defiant DFI-5997-BZ Guía De Uso Y Cuidado página 8

Operation (continued)
3
Setting the sensor for testing
NOTE: When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 8 seconds after all motion
is stopped.
Set the "ON-TIME" switch to the "TEST"
position.
Set the "DUALBRITE" switch to the "OFF"
position.
Slide the "SENS" switch to the "L" (low)
position.
Set the Adjustable Color Temperature dial to the
desired light color.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
TEST
C
OFF
5
Adjusting the SENS switch
To increase the sensitivity, slide the "SENS"
switch toward the "H" (high) position.
To decrease the sensitivity, slide the "SENS"
switch toward the "L" (low) position.
NOTE: The motion sensor (C) is more sensitive to motion
moving across the front of the sensor. The motion sensor
(C) is less sensitive to motion moving directly toward the
front of the sensor.
NOTE: The higher the "SENS" setting (sensitivity), the
greater the possibility of false triggering. To reduce false
triggering, slide the "SENS" switch toward the "L" (low)
setting.
1 MIN 5 MIN
TEST 20 MIN
ON TIME
L M H
SENS.
6H
OFF 3H DUSK TO DAWN
DUAL BRITE
1 MIN 5 MIN
20 MIN
ON TIME
L M H
SENS.
6H
3H DUSK TO DAWN
DUAL BRITE
C
L
6H
OFF 3H
Adjusting the motion sensor
4
detection zone
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
Watch the light. The light will come on and the
red LED will flash indicating motion has been
detected.
Stop, wait for the light to turn off, and then
begin walking again.
Continue this process until the detection zone
has been established.
If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
6
Adjusting the ON-TIME switch
NOTE: The "ON-TIME" switch determines the amount of
time the light will stay on full bright after all motion has
stopped. When the "ON-TIME" switch is set to the 1, 5,
or 20 minute position, the light will only come on during
the night.
Set the "ON-TIME" switch to the 1, 5, or 20
minute position.
1 MIN
TEST
L
OFF 3H
ON TIME
M H
SENS.
DUSK TO DAWN
8
C
5 MIN
20 MIN
ON TIME
M H
C
SENS.
6H
DUSK TO DAWN
DUAL BRITE
1 MIN 5 MIN
TEST 20 MIN
ON TIME
L M H