Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
2
Removing the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the
handle.
The water will not shut off
completely.
There is leaking from the
sink drain at the base of
the sink.
There is a low ow of
water.
Possible Cause
The bonnet nut has come loose and/or the
washer is dirty or damaged.
The cartridge is dirty or broken.
The sink has a rough or irregular surface.
The screen lter in the copper tubes is dirty. □
Squeeze
1
□
□
□
□
□
□
□
10
2
Pull
down
1
Solution
Tighten the bonnet nut.
Clean or replace the washer.
Remove the handle to check
the cartridge.
Clean or replace.
Apply additional silicone sealant
to the beveled side of the drain
ange.
Retighten and test for leaks.
Turn off the water supply at
angle stop and unscrew the
copper tubes from water supply
lines.
Remove the screen lter from
copper tubes and check for
debris.
Publicidad
