Beamz professional LED PARBAR 4Way Manual De Instrucciones página 4

HOW TO CONTROL THE UNIT
The LED FlatPAR-18x1Watt RGB IR DMX has four operating modes:
A DMX mode
B. Manual mode
C. Auto mode
D. Master / Slave Mode
After you have selected your desired mode or setting, you have to confirm it by pressing the "ENTER" button.
A. DMX MODE
This mode allows you to control each individual FlatPar with a standard DMX-512 controller. Press the "MENU" button until
"dxxx" is displayed. Press the " " and " " buttons to set the correct start address with a value between 1-512.
DMX connection diagram will
B. MANUAL RGB MODE
Press the "MENU" button until display shown "rxxx", "gxxx", "bxxx" or "uxxxx). Press " " and " " buttons to adjust the
intensity of the LEDs and confirm the setting with "ENTER".
C. AUTO MODE
There are 3 types of Auto modes to choose from;
- Instant (Pxxx)
- Smooth (Lxxx)
- Fade (Exxx)
The running speed is adjustable in value 000-255.
D. MASTER/SLAVE MODE
Connect the FlatPars via the connectors on the back of the fixture. Use the supplied signal and power extension to connect
Flatpar.
Connect the signal cable's
Start by the FlatPar with built-in IR-sensor (Master)! Connect the signal output of the first FlatPar (master) directly to signal
input of second FlatPar (Slave). Repeat this from the second to the 3rd and 4th FlatPar (all Slaves).
Connect the power cable's
Connect the IEC power connector in the output of the first FlatPar directly to IEC power input of second FlatPar. Repeat this
from the second to the 3rd and 4th FlatPar. Finally, insert the power lead with power plug in the first FlatPar and connect
with the outlet.
4
described later in this manual