Publicidad
Idiomas disponibles
Idiomas disponibles
MENU OPTION: RECORD
RECORDING OPTIONS
The record function is passcode protected. At initial startup, a 4 digit numerical passcode can be established in order to access the menu. Press the
down arrow to select first digit, when number is red, use + or - to select 0 through 9. Press the down arrow to move to the next number and continued until
desired 4 digit pin is finished. Press the down arrow to confirm. This passcode will also be used for accessing the playback menu and will be the same 4
digits. In order to access the menu again, you will be prompted to enter the passcode again.
Once the pass code has been set, you can set automatic recording upon start up by selecting the record menu by pressing the down arrow. Use the + or -
to select ON or OFF. Press the down arrow to exit and press M to exit the menu.
Enable/Disable Recording
A blue rectangle at the top of the monitor will indicate active recording as long as a mini SD card has been been installed and
formatted. See further sections for details. To enable or disable recording in split or quad view, press the down arrow on the
monitor or the OK on the remote.
Once OVERWRITE is enabled, any recording that takes place after the mini SD card is to capacity, the system will automatically start overwriting existing recordings.
See the table below for recording capacities.
To enable overwrite or to format a mini SG card
Using the monitor:
1. Press M to enter the Menu
2. Use the + or - to highlight the RECORD Option
3. Press the down arrow to enter the RECORD Option
4. Use the + or - to highlight the desired adjustment
5. Press M twice to return to the main screen
Mode
SINGLE (640x480x1)
14h
QUAD (320x240x4)
SPLIT (400x480x2)
13h
MENU OPTION: AUTOSCAN
AUTOSCAN OPTIONS
AUTOSCAN is disabled by default when all cameras are set to off in the AUTOSCAN menu. AUTOSCAN is enabled once one or more cameras are set to ON in the
AUTOSCAN menu. Once enabled, AUTOSCAN occurs as an additional image mode between the split and CAM1 image modes. The SCANTIME, or time interval
for each camera, is in seconds.
Using the monitor:
1. Press M to enter the Menu
2. Use the + or - to highlight the AUTOSCAN Option
3. Press the down arrow to enter the AUTOSCAN Option
4. Use the + or - to highlight the desired adjustment
5. Press the down arrow to enter the adjustment option
6. Use the + or - to change the settings
7. Press the down arrow to exit the adjustment option
8. Press M twice to return to the main screen
8G
16G
32G
64G
28h
55h
110h
11h
22h
43h
86h
25h
50h
101h
Using the remote:
1. Press MENU to enter the Menu
2. Use the < or > to highlight the RECORD Option
3. Press OK to enter the RECORD Option
4. Use the < or > to highlight the desired adjustment
5. Press MENU twice to return to the main screen
128G
220h
172h
201h
Using the remote:
1. Press MENU to enter the Menu
2. Use the < or > to highlight the AUTOSCAN Option
3. Press OK to enter the AUTOSCAN Option
4. Use the < or > to highlight the desired adjustment
5. Press OK to enter the adjustment option
6. Use the < or > to change the settings
7. Press OK to exit the adjustment option
8. Press MENU twice to return to the main screen
Page 8 of 11
Publicidad
