LG TDD16515 Manual Del Propietário página 18

Part 5 ELECTRICAL REQUIREMENTS FOR ELECTRIC DRYERS
Option 2: 3-Wire Connection with
a Power Supply Cord
lf your local codes or ordinances permit the
connection of a frame-grounding conductor to the
neutral wire, use these instructions. If your local
codes or ordinances do not allow the connection of
a frame-grounding conductor to the neutral wire,
use the instructions under Section 3: Optional
3-wire connection.
3-wire receptacle
(NEMA type 10-30R)
3-wire plug
Neutral prong
3-wire plug
Neutral prong
1 8
Spade terminals with
up turned ends
3/4 in. (1.9 cm)
UL approved strain relief
Ring terminals
Neutral (white or center wire)
Center terminal
block screw (silver)
Neutral grounding
wire (white)
Neutral grounding
wire (white)
Strain relief
External ground
connector
Option 3: Optional 3-wire
connection.
• If your local codes or ordinances do not allow the
connection of a frame-grounding conductor to the
neutral wire, use the instructions under this
section.
1. Connect neutral wire(white) of power cord to
center terminal block screw.
2. Connect ground wire of appliance and neutral
wire of power cord to center terminal block
screw.
3. Connect red and black wire to the left and right
terminal block screws.
4. Make sure that the strain relief screw is tightened.
and be sure that all terminal block nuts are on
tight and power cord is in right position.
5. Connect a independent ground wire from external
ground connector to proper ground.
Neutral grounding
wire (white)
Neutral wire (white)
External ground
connector
Separate ground
wire