6.2
Menu
mode
DMX mode
static colours
auto mode
sound mode
speed
mic sensitivity
edit colour
dimming
silent scene
slave
IR
6.3
Stand-Alone Mode
The device starts running in stand-alone mode after connection to the mains. This mode allows you to
use the device without controller.
6.4
Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device in a daisy chain.
All slave devices will then work synchronously with the master device.
Configure all slave units before connecting the master unit to the daisy chain.
6.5
DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
6.6
DMX Channel Values
Refer to page 3 of this manual.
7.
IR Remote Controller
BLACK OUT
Press this button to black out the current active mode. Press again to return.
AUTO
Enables you to run the automatic programmes.
1.
Press <AUTO>.
2.
Press <+> or <-> to choose the different programmes.
SOUND
Enables you to run the sound-controlled programmes.
1.
Press <SOUND>.
2.
Press <+> or <-> to choose the different programmes.
V. 01 – 22/09/2017
HQLP10010
programme
Addr
Stat
S01-16
Auto
Au1-2
Soun
So1-2
SPEE
SP1-9
SEnS
SE1-9
r000-255
Colo
g000-255
b000-255
dIMM
SILE
on/oFF
SLAV
InFr
on/oFF
7CH
4CH
3CH
2CH
dl1-9
silent scene at sound programme
Slave
9
description
d001-d512
static colours
auto programme
sound programme
speed
microphone sensitivity
red 0-100 %
green 0-100 %
blue 0-100 %
master dimming
slave mode
enable/disable IR remote
©Velleman nv