Publicidad
Idiomas disponibles
Idiomas disponibles
IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY OR
•
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR
FROM THE DATE OF ORIGINAL PURCHASE. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitations may not
apply to you.
OPERATIONAL
POSSIBLE CAUSE
ISSUE
Engine will not
No fuel.
start (see Engine
Pressure builds up after
Owner's
two pulls on the recoil
Manuall for
starter or after initial use
further engine
Choke lever in the "No
troubleshooting)
Choke" position
Spark plug wire not attached. Attach spark plug wire.
Engine switch in OFF po si tion Place engine switch in ON position
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time
No or low
Spray wand not in
pressure
high pressure
(initial use)
Low water supply
Leak at high pressure
hose fitting
Nozzle obstructed
Water filter screen clogged
Air in hose
Choke in the "Choke"
position
High pressure hose
is too long
TROUBLE SHOOTING GUIDE
22- ENG
SOLUTION
Add fresh fuel.
Squeeze gun trigger to relieve
pres sure
Move choke to the "Choke"
po si tion
Move choke to the "No Choke"
po si tion
See How to Use Spray
Wand instructions in the
Operation Section
Water supply must be at
least 5 gpm @ 20 psi
Repair leak. Apply sealant tape
if necessary
See Nozzle Cleaning
instructions in the
Maintenance section
Remove and clean filter. See
Cleaning Water Inlet Filter
paragraph in the Maintenance
section for the correct procedure
Turn off the engine, then the water
source. Disconnect the water
source from the pump inlet and
turn the water source on to remove
all air from the hose. When
there is a steady stream of water
present, turn water source off. Re-
con nect water source to pump inlet
and turn on wa ter source. Squeeze
trigger to re move re main ing air
Move choke to the "No Choke"
po si tion
Use high pressure hose under
100 feet (30 m)
Publicidad
