Safety Instructions; Description Of Parts; Normal Operation - Peach PS500-80 Manual De Instrucciones

Safety Instructions

Read and follow all instructions carefully.
Keep these instructions for future refer-
ence.
Always turn off and unplug the machine
before moving, cleaning or anything other
than normal operation. Otherwise serious
injury may result. Clean shredder with a
damp cloth, using a mild soap and water
solution.
Do not use abrasives or solvent-based
cleaners.
Turn the power switch off before removing
the waste bin
6
nect the power cord before opening the
shredder.
This product should never be placed near
a radiator or other heat source.
Do not allow anything to rest on the pow-
er cord. Do not place the power cord
where people may walk on it.
Do not attempt to service this product
yourself, as opening or removing covers
may expose you to the risk of injury. Also,
doing this will void the shredder's war-
ranty.
U nplug this product and contact technical
support if:
– The power cord or plug is damaged
or frayed.
– Liquid has been spilled on the product.
– The product has been exposed to rain.
– The product does not operate normal-
ly, even when the operating instructions
are followed.
– The product has been dropped, or the
casing has been damaged.
This shredder should be operated only
with an operator in attendance.

Description of parts

Switch
1
LED "OVERLOAD"
2
LED "OVERHEAT"
3
Bin-Full indicator light
4
LED "POWER"
5
Waste bin
6
. It is advisable to discon-
Transparent window
7
Cutter opening for CD
8
Installation / Setup
The switch located on top of the hous-
1
ing has 4 positions.
M ake sure the switch is set to the "OFF"
position.
Connect the power cord to any standard
230 Volt AC outlet.
It is normal for residual lubricant in the
motor to burn off during the first several
extended uses of your shredder. Should
you notice a slight burning odor or the
presence of small wisps of smoke during
the first several extended uses, you may
continue using the shredder. If either
symptom continues to occur after repeat-
ed use, please contact technical support
for assistance.

Normal Operation

Move the switch
the LED "POWER"
Insert paper to activate. The shredder
starts automatically and will stop as soon
as all the paper has gone through.
The shredding capacity is 14 sheets
(80g / m ) or 1 CD resp. Credit Card.
2
However, you should shred only one
type of these items at a time to avoid
causing an overload.
Never attempt to shred sealed envelopes.
Doing so may damage the shredder. Al-
ways remove and unfold envelope con-
tents completely before attempting to
shred. NEVER shred envelopes, labels
or anything with glue or any sticky sub-
stance as this will lead to paper jams.
Do not shred any wet paper, carbon pa-
per, or vinyl bags. The waste will stick in
the cutter and may lower the shredding
performance.
Although the shredder can safely shred
staples and paper-clips, you should re-
move them if possible. Industrial staples
must be removed.
to the "AUTO" position,
1
will light up.
5
7