Publicidad
Idiomas disponibles
Idiomas disponibles
From the BX-FD3 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the antenna turn-on wire
(if populated on the factory harness).
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
For models without SYNC:
• Connect the Red RCA jack labeled "FROM 3.5" to the right AUX-IN jack.
• Connect the White RCA jack labeled "FROM 3.5" to the left AUX-IN jack.
• Disregard the RCA jacks labeled "RSE/SYNC/SAT", they will not be used in this
application.
For models with SYNC:
• Connect the Red RCA jack labeled "RSE/SYNC/SAT" to the right AUX-IN jack.
• Connect the White RCA jack labeled "RSE/SYNC/SAT" to the left AUX-IN jack.
• Disregard the RCA jacks labeled "FROM 3.5", they will not be used in this application.
• Disregard the DIN plug, and the Red wire attached to it, it will not be used
in this application.
• The 3.5mm jack is to be used to retain steering wheel controls.
BX-FD3
Connections to be made
3
• For the radios listed below, connect the included female 3.5mm adapter
with Brown and Brown/White wires, onto the male 3.5mm SWC jack of
the BX-FD3. Any remaining wires, tape off and disregard:
• Eclipse: Connect the steering wheel control wire, normally
Brown, to the Brown/White wire of the adapter. Then connect
the remaining steering wheel control wire, normally Brown/White,
to the Brown wire of the adapter.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray)
to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire:
Connect the Blue/Yellow wire to the Brown wire.
Note: If your Kenwood radio auto detects as a JVC, manually set the
radio type to Kenwood. See the instructions under changing radio type.
• XITE: Connect the steering wheel control SWC-2 wire from the
radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack
into the AX-SWC-PARROT (sold separately), and then connect
the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
• For all other radios: Connect the 3.5mm jack of the BX-FD3
into the jack on the aftermarket radio designated for an external
steering wheel control interface. Please refer to the aftermarket
radios manual if in doubt as to where the 3.5mm jack goes to.
Publicidad
