This manual describes the installation and operation of the Model FW300007 non-catalytic wood heater. This
heater meets US Environmental Protection Agency's emission limits for wood heaters. Under specific
conditions this heater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU per hour.
Model No. FW300007
This unit has been listed by Warnock
Hersey Limited to meet or exceed ULC
S-627-00 Canada and UL 1482 U.S.
Contact your local building inspector
prior to installation.
A permit maybe required in your area.
2ft(635mm) HIGHER THAN
NEAREST POINT OF
3FT(1M) MIN
FROM ROOF
ROOF WITHIN 10ft(3M)
PENETRATION
MINIMUM OVERALL
G
HEIGHT FROM FLOOR
15FT(5M)
Unit must be placed on a noncombustible floor protection equivalent to 3/8" millboard.
Consult your local building authorities for further information.
CAUTION:
CERAMIC BAFFLE IS FRAGILE.
HANDLE
BEFORE REMOVING SECONDARY AIR
Twist spring handle
TUBES SUPPORT CERAMIC BAFFLE.
clockwise motion while pushing on to
handle; spring handle will "thread" down
to desired location.
21
Desired Burn Setting
19
Med / Low
20
Med / High
1 . M a x i m u m b u r n t i m e s a n d h e a t o u t p u t s a r e b a s e d o n l a b o r a t o r y t e s t i n g u s i n g f u l l l o a d s o f s e a s o n e d
h a r d w o o d s , a n d m a y v a r y i n i n d i v i d u a l u s e d e p e n d i n g o n h o w t h e s t o v e i s o p e r a t e d , t y p e a n d m o i s t u r e c o n t e n t s o f f u e l ,
a n d o t h e r f a c t o r s . M a x i m u m b u r n t i m e s a r e a c h i e v e d u n d e r d i f f e r e n t o p e r a t i n g c o n d i t i o n s t h a n a r e m a x i m u m h e a t o u t p u t s .
2 . T h e s e v a l u e s a r e b a s e d o n o p e r a t i o n i n b u i l d i n g c o d e - c o n f o r m i n g h o m e s u n d e r t y p i c a l W i n t e r c l i m a t e c o n d i t i o n s i n t h e
n o r t h e a s t e r n U . S . I f y o u r h o m e i s o f n o n s t a n d a r d c o n s t r u c t i o n ( e . g . U n u s u a l l y w e l l - i n s u l a t e d , b u i l t u n d e r g r o u n d , o r i f y o u l i v e
i n a m o r e t e m p e r a t e c l i m a t e ) , t h e s e m a y n o t a p p l y. S i n c e s o m a n y v a r i a b l e s a f f e c t p e r f o r m a n c e , c o n s u l t y o u r C F M A u t h e r i z e d
D e a l e r t o d e t e r m i n e r e a l i s t i c e x p e c t a t i o n s f o r y o u r h o m e .
3 . U n d e r s p e c i f i c c o n d i t i o n s u s e d d u r i n g E PA e m i s s i o n t e s t i n g .
MADE IN/FAB AU/HECHO EN CANADA BY CFM Corporation, 410 Admiral Boulevard, Mississauga, ON L5T 2N6 800-668-5323 www.cfmcorp.com
NOTE: Retain this sheet for future reference
6" Flue Required
Figure A: Clearance from combustible constructions
A minimum clearance of 18" (457mm) to the chimney connector
may be required by the authority having jurisdiction.
From Heater
From Chimney Connector
A
Sidewall..........18-1/2" (470 mm)
D
Sidewall................24-1/2" (622 mm)
B
Backwall...............14" (351 mm)
E
Backwall................17-1/2" (445 mm)
C
Corner..................11" (279 mm)
F
Corner...................17-1/2" (445 mm)
G
Ceiling..................57-3/4" (1467 mm)
BACK WALL
B
E
8"(203mm)
A
D
*16
**18
8"(203mm)
8"(203mm)
Figure "A"
*16"(406mm) U.S.A.
**18"(457mm) Canada
CAUTION: Do not open fire-door to a point
where it would be in contact with the
combustible sidewall.
OPTIONAL FAN
An optional heat exchange blower is available
for this wood burning appliance. To order please
see the local dealer where you purchased
your appliance.
SPRING
in counter
CAUTION: BRICK FOR ASH DRAWER
MUST BE INSTALLED BEFORE
OPERATION OF WOOD HEATER
Inlet Air Control Settings
Inlet Air Setting
Low
Closed Fully
¼ Open
¾ Open
High
Fully Open
Part No S19570 Rev09
10
11
BACK WALL
16
C
F
16
C
18
F
Diseño de colocación de los ladrillos
ITEM NO.
NO.
LEYENDA
DOOR ASSEMBLY
DOOR - NO GLASS
1
2&3
GLASS AND GASKET
3
1/8" GLASS GASKET
4
5/8" DOOR GASKET
5
LARGE SPRING HANDLE
6
SMALL SPRING HANDLE
7
GLASS CLIP
8
GLASS CLIP
9
SCREW
10
HINGE PIN
Approx. BTU Output
11
PUSH NUT
12,000
12
BRASS BODY TRIM
13,400
13
BRASS ASH FENDER TRIM
17,700
14
FIREBRICK LT 7-3/4"x4-7/16"x1-1/4"
55,100
FIREBRICK LT 4-1/2"x4-7/16"x1-1/4"
15
16
FIREBRICK LT 9"x4-7/16"x1-1/4"
17
FIREBRICK LT 9"x2-1/2"x1-1/4"
18
FIREBRICK FOR ASH DRAWER
19
SECONDARY AIR TUBE
20
COTTER PIN
21
CERAMIC BAFFLE
22
ASH DRAWER ASSEMBLY
1
2
5
17
16
16
16
16 16
14
14
14
16
16
16
14
15
16
Brick Pattern
Disposition Des Briques
PARTS LIST
LISTE DES PIÉCES
DESCRIPTION
DESCRIPTION
PORTE MONTÉE
PORTE - SANS LA VITRE
VITRE DE JOINT D'ÉTANCHEITÉ
JOINT DE LA VITRE 1/8po
JOINT DE LA PORTE 5/8po
GRANDE POIGNÉE À RESSORT POMO DE RESORTE, GRANDE
PETITE POIGNÉE À RESORT
FERRURE POUR LA VITRE
FERRURE POUR LA VITRE
VIS
GOUPILLE DE CHARNIÈRE
ÉCROU À RESSORT
GARANTURE DE CHASSIS (LAITON)
GARANTURE DE GARDE-FRU (LAITON)
BRIQUE 7-3/4pox4-7/16pox1-1/4po
BRIQUE 4-1/2pox4-7/16pox1-1/4po
BRIQUE 9pox4-7/16pox1-1/4po
BRIQUE 9pox2-1/2pox1-1/4po
BRIQUE POUR LE CENDRIER
TUBE D'AIR SECONDARE
GOUPILLE FENDUE
DÉFLECTRUR DE CÉRAMQUE
L'ASSEMBLEE DE TROIR DE CENDRE
8
3
4
12
9
6
13
22
QTY
PART NO.
LISTA DE PIEZAS
QTÉE
NO.de PC
DESCRIPCIÓN
CANT.
ART NO.
UNIDAD DE PUERTA
1
S31139
UNIDAD DE PUERTA SIN VIDRIO
1
S41091
VIDRIO Y EMPAQUETADURA
1
S31141
EMPAQUETADURA DE 1/8" PARA EL VIDRO
4.3'
S15001
EMPAQUETADURA DE 5/8" PARA LA PUERTA
5.1'
S15011
1
S11007
POMO DE RESORTE, PEQUEÑO
1
S11008
PRESILLA PARA EL VIDRIO
1
S37026
PRESILLA PARA EL VIDRIO
2
S37018
TORNILLO
7
S11086
DEPIENDA ALFILER
2
S11005
UNIDAD DEL DEFLECTOR
2
S11090
MOLDURA DE LATÓN PARA EL CUERPO DEL CALEFACTOR
1
S32592
MOLDURA DE LATÓN DEL PROTECTOR CONTRA LA CENIZA
1
S32593
4
S16222
LADRILLO REFRACTARIO 7-3/4"x4-7/16"x1-1/4"
LADRILLO REFRACTARIO 4-1/2"x4-7/16"x1-1/4"
1
S16046
LADRILLO REFRACTARIO 9"x4-7/16"x1-1/4"
15
S16040
LADRILLO REFRACTARIO 9"x2-1/2"x1-1/4"
1
S16216
LADRILLO PARA DEPÓSITO DE CENIZAS
1
S16214
TUBO SECONDARIO DEL AIRE
4
90000160
ALFILER DE COTTER
S11421
4
DEFLECTOR DE CERÁMICA
1
90000161
1
S31329
ASAMBLEA DE CAJON DE CENIZA
7