POWERSLIDE HP-S909 Manual Del Usuario página 12

a) Putting on the wrist protectors:
Check that the size of the protectors is suitable for you, i.e.:
• the protector must not slip or twist,
• it must fully protect the wrist,
• your freedom of movement must not be restricted
• Both wrist protectors must be tight enough to prevent any slippage and thus
provide maximum protection.
Attention: do not tighten too much to avoid choking the blood circulation.
3/ PRECAUTIONS:
• If, after following these instructions, the protector does not fit you, then perhaps
the size or the protector is unsuitable for you. In this case, choose another
protector.
• Before using the schooners, check that all parts are present and that nothing
unusual can be detected when touching them.
• These pads are designed for roller sports (roller skates, skateboards and skates).
Therefore, they may not be suitable for other sports.
• Any damage found on the product (detached foam; cracked or broken shell or
even dirt, etc.) requires immediate replacement.
• During use (repeated impacts, cleaning, friction during use), the protectors may
become compressed. It is then in the interest of the sportsman to provide for
appropriate replacement.
• Avoid contact with chemicals or extreme temperatures as this may reduce the
protective effect.
• If the self-adhesive Velcro strips lose their adhesive power, they must be replaced
immediately with new ones.
4/MAINTENANCE AND STORAGE
• This product should be disposed of no later than 5 years after the date of
production or after 3 years of normal use
• Avoid storing the pads in humid environments.
• We recommend storing them in ventilated and dry rooms to ensure the removal of
perspiration
• Avoid temperatures below 5°C or above 50°C
• Avoid direct sunlight
• Do not wash. Clean only with damp cloth or brush. Use clear water only.
• Do not bleach, do not iron, do not put in dryer, do not dry clean.
• Let the protectors dry at room temperature
12