Publicidad
Idiomas disponibles
Idiomas disponibles
6
Troubleshooting
Won't build pressure
Fig. 1
1. Disconnect plunger rod from cap A by removing the hitch pin and disengaging the plunger (Fig. 1).
2. Pull cap A and pull plunger B out of the tank. Unthread cap L and remove pump cylinder C (Fig. 2).
3. Remove mono valve D & K from bottom of cylinder B & C by pushing on the valve stem until the mono
L
4. Drop in the mono valve, stem upside down, into the cylinder and push the stem of the valve through the
5. Before replacing pump assembly in the tank:
a. Be sure supply tube extension G is inserted into the pump cylinder C and supply tube F, in plunger cap A,
b. The gasket J in the cap A must be properly seated and the cap A firmly tightened on plunger B
c. Lubricate plunger O-ring E with petroleum jelly. Do not use oil.
d. Place pump cylinder C in tank and thread cap L on tank opening. Insert plunger B through cap L.
e. Reassemble plunger rod to plunger cap A and install hitch pin.
Won't pump or is difficult to pump
Valve
Stem
1. Follow steps 1 and 2, above.
2. If supply tube extension G is not firmly in plunger cylinder C, reinsert it.
3. Unthread pump cap A by turning counter clockwise. If there is fluid in the cylinder, empty and
4. Follow steps 5, above.
Won't Spray
1. Be sure nozzle on wand is not tightened down too far.
2. If that doesn't work disassemble discharge line,(wand, hose and supply tube.) Flush and
3. If that doesn't work, follow directions in WON'T BUILD PRESSURE, 1, 2, and 3 above, and be sure supply
Squeeze the poly Thrustless™ valve lever until
spray stops.
Dispose of left over spray material according to
spray manufacturer's directions
valve is loose in the cylinder.
hole in the pump cylinder until the valve snaps into place. Use a broom handle or similar blunt object to
press on valve. The solid top mono valve D goes into cylinder B. The dish top mono release value K goes
into cylinder C.
firmly seated.
by turning clockwise.
clean out thoroughly. Note: Fluid will enter the cylinder if the pump cap has not been threaded
down firmly, when pumping began.
reassemble. See NOZZLE instruction, right.
tube F and Supply Tube Extension G are in position.
aLWaYS rELEaSE prESSUrE BEForE opEnInG or SErVICInG
Important!
SpraYEr
ALWAYS be sure all caps are threaded all the way on
and the hose clamp is securely fastened
4
Publicidad
