Glacier bay 67623-6027H2 Guía De Uso Y Mantenimiento página 5

Installation (continued)
3
Installing the drain body
□
Apply silicone sealant (not included) under the
drain ange (E) and place the drain ange (E)
into the drain hole of the sink.
□
From underneath the sink, screw the drain
body (H) onto the drain ange (E). Ensure that
the opening (1) for the ball rod on the drain
body (H) faces towards the rear of the sink.
□
Tighten the rubber washer (F) and lock nut (G)
on the drain body (H). Do not overtighten.
□
Open the easy install rotating clip (I).
F
E
1
H
G
1
Open
I
4
Installing the stopper and ball
rod
□
Insert the stopper (D) into the drain hole in the sink.
□
Insert the ball rod (J) into the drain body (H) and
through the hole of the stopper (D). See insert 1.
□
For easier removal and cleaning, rotate the
stopper (D) 90 degrees so that the ball rod (J)
does not go through the hole in the stopper (D).
See insert 2.
□
Make sure the horizontal rod (J) insert into the
drain body (H) completely, as shown (3).
□
Close the easy install rotating clip (I).
Insert 1
D
1
H
3
5
Please contact 1-855-HD-GLACIER for further assistance.
Insert 2
J
Close
I
HOMEDEPOT.COM