LG OLED55G3PSA Manual Del Usuario página 7

How to fix anchors and screws
(Except for OLW480B, LSW440B)
Please make sure that:
• Check that the material and thickness of the wall and finishing material
comply with the installation manual. Before beginning the mounting
process, you must be sure the wall is able to support the weight of the
TV.
• Should use the enclosed anchors and screws on crack-free concrete walls.
• Never install the product on a plasterboard or wall made of paper or
medium-density fiberboard (MDF). When it is necessary to install the
product on such wall, anchor screws must be fastened to retaining walls
(concrete) or wood Stud inside the finishing material.
• The wall mount should be attached to a stud. This usually will not be a
problem, but depending upon individual circumstances, there may be
cases when the ability to mount into a stud is not possible. In this case,
there are a variety of drywall anchors, such as toggle bolts, which may
provide a solution. If using drywall anchors, please be sure the anchors
and the wall have the ability to support the weight of your TV. Please
note that the supplied anchors may not be the correct ones for your
individual situation, so you should check with a local professional.
• Other unspecified walls must be capable of supporting pullout loads of
over 70 kgf (686 N) and shear loads of over 100 kgf (980 N) per fastener.
• Use an Ø 8 mm drill bit for concrete and a hammer (impact) drill or
Ø 4 mm drill bit for wood stud to drill holes.
For installation on concrete wall
Wall mounting anchor
Wall mounting screw
1 Drill holes in anchor locations with a drill bit of Ø 8 mm to a depth of
80 mm to 100 mm.
2 Clean the drilled holes.
3 Insert the enclosed anchors for fixing the wall mount into the holes. (Use
a hammer when inserting anchors.)
4 Push the wall mount support closely toward the wall to match the hole
locations.
5 Tighten screws for fixing the wall mount to the holes. At this time, tighten
the screws to a torque of between 45 kgf/cm to 60 kgf/cm.
For installation on wood stud
Use the Ø 4 mm drill bit for wood to drill holes with the depth of 76 mm.
(Clean the drilled hole.)
Without using the wall mounting anchor, fasten the wall mounting screw
directly to the wood stud.
After Installation
• When connecting additional cables from the sides, we recommend
holding the centre of the TV horizontally or vertically and pulling the
product to make sure there is sufficient distance from the wall before
connecting.
• When connecting additional cables from the bottom, we recommend
releasing the TV from the wall mount before connecting.
• Use cable management systems to arrange the cables at the bottom of
the TV as shown below. Cable managements are not provided with the
product, so purchase them separately.
• After installing the product, be sure to use it adhered to the wall.
- Using the product while it is not adhered to the wall may damage or
shake the product.
Drywall
76 mm
Wood stud
(For example)
7