4. Unscrew the lower hinge bracket using the 5/16 hex socket driver.
Screw it firmly into the corresponding screw holes on the opposite
corner of the unit.
5. Set the refrigerator back on its feet and remove two black rubber plugs
from the corner of the upper surface. These plugs should be placed
into the holes left after removing the upper hinge plate.
6. Set the door onto the bottom hinge bracket and fix it in place by
inserting the upper hinge (with its gasket) and screwing the upper hinge
bracket into position. Test that the door opens and shuts properly and
is correctly aligned before fully tightening the screws.
7. Screw the hinge cover into place.
Electrical Connection
IMPORTANT!
For your personal safety, this appliance must be properly
grounded. In the event of an electrical short circuit, grounding reduces the risk of
shock by providing an escape route for the electric current. This appliance is
equipped with a cord having a grounding wire with a grounding plug. The plug
must be inserted into an outlet that is properly grounded and installed. Consult a
qualified electrician or service center if you do not completely understand the
grounding instructions. If doubt exists as to whether the appliance is properly
grounded, have a qualified electrician check the circuit to make sure the outlet is
properly grounded.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD
(GROUND) PRONG FROM THE POWER CORD.
Use of Extension Cords
Avoid the use of an extension cord because of potential safety hazards under
certain conditions
6